Turning Equipment:
- 3 WARNER & SWAYSEY Turret Lathe, 10" Chuck & Collet Adaptor
- #5 WARNER & SWAYSEY Turret Lathe, 12" Chuck & 12" Air-Chuck
- SOUTH BEND Engine Lathe, 6" Chuck, 42" Ways.
Milling Equipment:
- LAGUN Vertical Mill, 42" Table with Digital Read Out
- CINCINNATI Vertical Mill, 42" Table with Digital Read Out
Misc Equipment:
- Dual Wheel Polishing Machine.
- Vibratory DeBurring Bowl, 42" Diameter.
- MEDALIST PEERLESS, 16" Capacity Bandsaw with 72" Stroke Auto-Feed.
- DURA PRESS, 25 Ton Hydraulic Press.
- LINCOLN, 220 Volt, 170 AMP MIG Welder.
- LINCOLN, 220 Volt, 150 AMP ARC Welder.
Grinding Equipment:
- #2 BROWN & SHARP Universal O.D. Grinder, 32" Center to Center, 9" 4-Jaw Chuck & JACOBS Collet Chuck.
- #13 BROWN & SHARP Universal O.D. Grinder, 26" Center to Center, 4" 4-Jaw Chuck.
- NORTON O.D. Grinder, 6" 4-Jaw Chuck.
- RIVETT O.D. Grinder, 1-5/8" Collet Capacity.
We manufacture new pistons for rack shafts that fit:
- Ford
- ’03-’04 Expedition
- ’03 F-150
- Lincoln
- ’03-’04 Navigator
- Jeep
- ’05 Jeep Grand Cherokee
- Cadillac
- ’04-’05 SRX
- ’05 Saville
- Volvo
- New two-piece Rack shaft
- Swedging Tool—For installing new pistons
- Rack-Shafts Metalizing
- Impact Tool-Poppet valve removal tool
|
Our Machines & Equipment
 |
JOHNSFORD TC20
- 3-Axis Turning Center
- Bolt Hole Patterns Keyway
- 2" Capacity AUTO BAR Bar Feeder
- 8" Chuck
- 4,500 RPM
|
 |
HITACHI SEIKI HT20J
- 2-Axis Turning Center
- 2" Through Hole
- 8" Chuck
- 5,000 RPM
|
 |
HITACHI SEIKI HICELL 23II
- 4-Axis Turning Cell for Off Center Milling/Drilling/Tapping
- 2-1/2" Capacity LNS Bar Feeder
- 10" Chuck
- 4,500 RPM
|
 |
Our Metalizing Equipment
We build our own specialized metalizing equipment.
|
|
